505 Spray and Fix Temporary Fabric Adhesive

Home » Products » 505 Spray and Fix Temporary Fabric Adhesive

505 Spray and Fix Temporary Fabric Adhesive

$15.99 $12.96

505 Spray and Fix Temporary Fabric Adhesive is a temporary, repositionable, fabric adhesive used to temporarily bond fabric. Odorless, colorless, no mist, does not gum sewing needles. Use for machine applique, quilting, basting, holding fabric to stabilizers in machine embroidery and hemming.

Acid Free – No CFC’s


505 Spray and Fix Temporary Fabric Adhesive

General Use
– Protect work surface with disposable paper
– Shake 505 Spray & Fix can before using
– Hold can 12 in. / 30 cm. from fabric surface
– Always spray 505 Spray& Fix on the wrong side of the smaller fabric piece to be glued
– A light spray of 505 Spray& Fix is sufficient. A little goes a long way.
– Using your hand, press firmly in place to secure the piece to the larger fabric
– A misaligned piece may be removed and repositioned several times for 15 to 20 minutes after spraying
– Machine sew in place as usual
– Cleanup with soap and water
– Read label on can for storage, disposal, and first aid
– Test on all fabrics before using


Work one half of the quilt at a time.

  1. Read general instructions
  2. Roll top back to the 1/2 way point
  3. Spray backing in 1 foot intervals for better control
  4. Press batting in place by hand, then spray batting in 1 foot intervals
  5. Press top in place by hand
  6. Repeat on opposite half of layered quilt


  • Read general instructions
  • Lightly spray 505 on the stabilizing interfacing

  • Position interfacing behind the area to be embroidered
  • Using your hand, press in place to secure
  • Embroider your pattern

  • Remove excess interfacing if needed


  • Read general instructions
  • Draw shape on paper

  • Cut out shape and spray 505 lightly on paper shape.

  • Place on fabric using the pressure from your hand to secure in place

  • Cut around paper shape
  • Separate the fabric from the paper

  • Spray 505 on the wrong side of the applique shape
  • Arrange applique shapes on background fabric. Press in place by hand.

  • Reposition if needed


Celtic Applique & Stained Glass Applique

  • Read general instructions
  • Prepare your bias fabric strip with the seam pressed at the back center of the strip

  • Place the bias strip on a protected surface and spray evenly
  • Trace pattern on a background fabric

  • Follow pattern with the 505 sprayed bias tape making sure to begin and end where the pattern crosses over itself. Press by hand to secure in place.

  • Machine or hand sew in place

Freezer Paper Applique

  • Read general instructions
  • Cut out shape from freezer paper or regular paper

  • Cut out fabric 1/4″ larger than paper pattern. If using freezer paper, iron in place. If using regular paper, spray with 505.

  • Clip curves if needed

  • On a protected surface spray the shape with 505 evenly. Finger press the seam allowance to the paper then position on background fabric.
  • Sew in place by hand or machine